push buttons and displays electronic interfacesIMEM

Electronic Interfaces

image
Dot matrix displays and 7 segments
  • Power supply: 24 V DC
  • Easy configuration by means of a DIPSWITCH.
  • They allow to visually display up to 32 stops
  • The dot matrix display can show the mezzanine floor ( showing an 'M' )
  • They show the travel direction by means of arrows.
  • They show the travel including those below the groundfloor.
  • Possibility to programme alphanumeric characters indicating the floor (only in dot matrix)
  • The dot matrix display can be programmed to show alphanumeric symbols indicating the landing stop.
Synthetiser IMEM STV 300
  • Possibility of recording up to 32 messages.
  • Serial communication, Binary code or 'wire to wire' controlled by the lift.
  • 3 leds that show the actual state of the equipment.
  • Message recording without using any kind of interface.
  • Microphone incorporated in the system.
  • In 'Night Mode', it reduces the volume in 50%.
  • Volume and reproduction tone are adjustable by using the same device.
  • It allows manual reproduction of message, so they can be checked.
  • Two reference voltages. 24 V DC and 0 V DC
  • Power supply of 12 V DC available for external use
Load weighting device 'SCM
  • Based on a high precission microswitch.
  • Easy installation on the car frame of the lift.
  • Continous acquisition of the car buffer deformation.
  • Easy calibration by adjusting just one screw. 

Contact



Peñacastillo-C/ Adarzo 167B-39011
SANTANDER - (SPAIN)

Telephone (+34) 942 33 33 09
Fax Admin. (+34) 942 34 48 58

Copyright © 2009 ASCENSORES IMEM SL | Confidentiality & data protection policy